
Applications
Genesys? power supplies have been designed to meet the demands of a wide variety of applications.
Test and Measurement
Last-Setting memory simplifies test design and requires
no battery backup.
Built-in RS-232/RS-485 gives maximum system flexibility
along with 0-5V and 0-10V, selectable analog
programming.
Wide range of available inputs allows testing of many
different devices.
Semiconductor Burn-in
Safe-Start may be ENABLED to re-start at Output OFF
to protect load.
Wide range input (85-265Vac) with Active Power Factor
correction rides through input transients easily.
Component Test
High power density, zero stacking and single wire parallel
operation give maximum system flexibility.
Rear Panel Description
Laser Diode
OVP is directly set on Voltage Display, assuring accurate
protection settings.
Current Limit Fold Back assures load is protected from
current surges.
Heater Supplies
Smooth, reliable encoders enhance front panel control.
Remote analog programming is user selectable 0-5V or
0-10V.
RF Amplifiers and Magnets
Robust design assures stable operation under a wide
variety of loads.
High linearity in voltage and current mode.
1.
2.
3.
4.
5.
6.
Remote/Local Output Voltage Sense Connections.
DIP Switches select 0-5V or 0-10V Programming and other functions.
DB25 (Female) connector allows (Non-isolated) Analog Program and Monitor and other functions.
RS-485 OUT to other Genesys? Power Supplies.
RS-232/RS-485 IN Remote Serial Programming.
Wide-Range Input 85-265VAC continuous, 47/63Hz with Active Power Factor Correction (0.99 typical)
AC Input Connector: IEC320.
7. Exit air assures reliable operation when zero stacked.
8. Output Connections: Rugged busbars for 6V up to 60V Output; Connector for Outputs >60V.
9. Optional Interface Position for IEEE 488.2 SCPI (shown) or Isolated Analog Interface or LAN Interface.
2